
Fisher and Paykel Filter for RS90AU1 , RS90A1
842802 / 839041 /842802WF

This filter is located on bottom front of your appliance ( Toe kick grilles)
Instructions:
1. Note: Filter must be pushed firmly into receiver and turned until filter is locked in place. If filter is not locked correctly, water will not flow.
2. DO NOT use any tools to install this filter.
3. Twist the old filter a quarter-turn counter clockwise.
4. Pull the filter straight down and discard (don't worry, the water will shut off automatically).
5. Remove the reusable colour-keyed knob from the end.
6. Slide the knob onto the end of the new filter.
7. Push the new filter into the fridge until it stops and twist the filter a quarter-turn clockwise. Note: Following a successful clockwise quarter-turn installation, grip on reusable colour-keyed knob may not align parallel with refrigerator’s bottom grill grates.
8. Reset your change filter light (if your fridge has one).
9. Flush filter with 3-4 gallons of with water until water runs clear. Some noise is not uncommon as air is purged from the system.
10. If filter sets for several days without use, flush a quart of water through the filter to remove stale water from refrigerator water lines.
Resetting Your Filter Change Indicator:
1. Press the light switch (the one that the refrigerator door presses every time you close the door) 5 times within 10 seconds or if the fridge has a filter button, press and hold it for 5-10 seconds.
842802WF Operating Specification:
Actual Size (in): 9 1/2 inches (length) x 1 5/8 inches (outside diameter)
Actual Size (cm): 24.13 x 4.1275
Media: Coconut Carbon
Primary Filter Media: Activated Carbon Block
Filter Life (liters): 757.08
Filter Life (months): 6 months
Micron Rating (Nominal): 0.5
Operating Pressure (psi): 30 - 120
Operating Temperature (°F): 33 - 100
Operating Temperature (°C): 0.6 - 37.8
Flow Rate (gpm): 0.5
Flow Rate (lpm): 1.89
Certifications: Filter cartridge has been Tested and Certified by NSF International against NSF/ANSI 42 for materials and structural integrity requirements
- 99% of Lead
- 99% of Mercury
- 99% of Cysts
- 99% of Asbestos
- 93% of Toxaphene
- 77% of Altrazine
- 99% of Lindane
- 97% of Chlorine
- 96% of rust, dirt, sand, and sediment (1 to 15 microns in size)
This filter suit for below
839041, 81099, RS90AU, EFF-6001a
839041, RS36A
e522blxfdu4, e522blxfdux4
RS90AU1
842802
IF YOU ARE NOT 100% SATISFIED WITH YOUR PURCHASE WE OFFER A FULL REFUND OR REPLACEMENT.
waterfilterforfridge.com.au
More inquiry about this filters? Call us 1300 767 072 or Email us sales@waterfilterforfridge.com.au
|
|




Compatible Models
Please refer to the product description above for compatible filter numbers, refrigerator models, and system model information.
If you cannot find your model number or are unsure whether this product is suitable for your system, please contact us before purchasing.
Contact Us for Compatibility SupportInstallation Guide
Please use the general guide below to help identify your filter type and follow the correct replacement process. Filter location and replacement steps may vary depending on your refrigerator or water filtration system model. Always refer to your appliance manual for the exact filter location and specific instructions.
Need Help Finding the Correct Filter?
Before ordering, compare your old filter, check the model number or filter code, and confirm the connector type. If you are unsure, please contact Water Filter Distributors for assistance.
Whole House System Installation Manual
For whole house filtration systems, please refer to the detailed installation manual below. Professional installation by a licensed plumber is recommended.
View Whole House Installation ManualTwin Cartridge Under Sink Installation Guide
For twin cartridge under sink systems, please refer to the installation guide below. This guide is suitable for systems supplied with a dedicated faucet, diverter valve, tubing and installation kit.
Important Notes
- Filter location and replacement steps may vary depending on your appliance or system model.
- Flush approximately 5–10 litres or 3–5 minutes of water after installation.
- Use with cold potable water only.
- Check for leaks after installation and reinstall if necessary.
- Always follow your appliance manufacturer's instructions.
Certification & Quality Assurance
Water Filter Distributors is operated by Mexi Trading Pty Ltd, an Australian owned and operated company. Our products are supplied with a strong focus on quality, safety and trusted filtration performance.
Important Certification Notice
- Certification details may vary depending on the specific product model.
- Please refer to the product description, packaging or official documentation for model-specific certification information.
- If you require confirmation for a specific product, please contact Water Filter Distributors before purchasing.


